Most of the pruning calls I get in Saint John start with a look, not a plan. A branch hangs over the driveway, a fork looks weak, or the tree just seems crowded. I am a local arborist, and I have spent years working on the maples, oaks, birches and spruces that grow in this city's yards and along its streets. Pruning is not about making a tree look tidy. It is about removing what will fail, correcting what will rub, and training young trees so they do not become a problem later. This guide explains what I do, when I do it, and why I make every cut with the tree's health in mind.
What tree pruning actually is
Tree pruning is the selective removal of branches to improve a tree's structure, health and safety. It is not the same as topping, which is the indiscriminate cutting back of a crown and which I refuse to do. When I prune, I am looking at the tree's architecture: the unions where branches meet the trunk, the angle of attachment, the presence of deadwood, and the way the tree distributes weight. A proper prune removes dead, dying or diseased wood first. Then I look at branches that cross and rub, because a wound that keeps reopening is an entry point for decay. I also thin weak forks that tend to split in the big post-tropical storms we get off the bay. For young trees, pruning is about training a strong frame early, so the tree grows into a shape that can carry its own weight without failing. Every cut I make has a reason, and I explain that reason before the saw goes in.
Why it matters in the Saint John area
Pruning is necessary because trees do not heal; they compartmentalize. A clean cut lets a tree seal off the wound, while a ragged tear or a stub invites rot and insects. Removing deadwood before it falls is the most obvious safety measure, especially after the windstorms and ice storms that hit this region. But the bigger reason is structural. A weak fork, a co-dominant stem, or a branch with included bark can look fine for years and then fail all at once under snow load or a gust off the bay. I have seen large trees come down in the middle of the city after storms like Dorian and Lee, and almost every one of them had a visible defect that could have been corrected years earlier. Pruning also improves air flow and light penetration, which reduces fungal pressure. It is cheaper to prune a young tree than to remove a mature one that has become a hazard.
When to do tree pruning?
For most trees, my preferred window is late fall through early spring, when the tree is dormant and the structure is visible without leaves. That is also when wounds close over faster in the spring push of growth. There are exceptions. Maples and birches bleed heavily if pruned in late winter or early spring, so I schedule them after the leaves have fully expanded or in midsummer. Oaks are best pruned in the dormant season to reduce the risk of oak wilt, which is not yet established here but is worth respecting. Deadwood can be removed at any time of year. As for signs, look for dead branches that have lost their bark or are brittle, branches that cross and rub, forks with a tight V shape or included bark, and any lean that has changed since the last storm. If a limb is hanging, call right away. Otherwise, a seasonal prune keeps a tree in good shape.
How I work in Uptown
The process starts with a phone call. I ask a few questions about the tree and the site, then I come out for a free estimate. I walk the property with you, look at the tree from the ground and, if needed, from above. I explain what I see, what I would remove, and what I would leave. I never pressure a removal if pruning will do. Once you approve the estimate, we set a date. On the day, I arrive with my truck and chipper, and I set up safely: I check for hydro lines, especially the private service entrance from the pole to your house, and I keep my distance from any live wire. I climb the tree myself or use a lift if the site allows. Every cut is explained before I make it. I remove the debris, chip the smaller branches, and leave the wood if you want it. I rake and blow the work area clean before I leave. You get a free estimate and a clear explanation, not a sales pitch.
The different cases
Not every pruning job is the same. Here are the cases I see most often in Saint John. Young tree training: I select a central leader, remove competing stems, and space the scaffold branches so the tree grows a strong frame. Crown cleaning: removing dead, dying, diseased, and rubbing branches from a mature tree. Crown thinning: selective removal of inner branches to improve light and air flow without changing the tree's shape. Crown raising: lifting low branches for clearance over a driveway, roof, or sidewalk. Structural pruning: reducing co-dominant stems and weak forks that could split. Storm damage pruning: removing broken limbs and stubs after a windstorm or ice storm, and assessing whether the remaining structure is sound. Hazard pruning: removing a limb that threatens a house, a power line, or a public area. I also prune cedars and hedges, but that is a different service. In every case, I look closely at every union and every lean before I cut.